Programming
the
R2LC
Receiver
with
the
Cab-1
The
R2LC
Command
module
is
a
very
flexible
device
and
can
be
programmed
to
operate
all
the
features
of
different
locomotives.
For
example,
there
are
five
(5)
general
purpose
outputs
that
can
be
programmed
to
operate
different
functions
such
as
directional
headlamps,
strobe
light,
cab
lights,
smoke
unit,
or
electrocouplers.
Use
the
table
below
to
determine
which
features
of
your
engine
you
need
to
operate
from
your
CAB-1.
Then,
use
the
corresponding
feature
code
to
program
your
R2LC |
Code | Engine Type | Feature 1 | Feature 2 | Feature 3 | Feature 4 | Feature 5 |
0 | Steam w/ Signalsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Smoke Unit |
1 | Diesel w/ Signalsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Strobe Light |
2 | Diesel w/ Signalsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Cab Light |
4 | Steam w/ Railsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Smoke Unit |
5 | Diesel w/ Railsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Strobe Light |
6 | Diesel w/ Railsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Cab Light |
8 | Diesel w/ Railsounds | Headlamp | Rear Lamp | Front Coupler | Rear Coupler | Smoke Unit |
To
program
the
engine
features,
1. Set the engine PROG/RUN switch to PROG. 2. Place the engine on the track and apply power. 3. On the CAB-1, press [ENG] then the number (1 - 99) for the locomotive. 4. Press [SET]. 5. Press [AUX1] [N], where N = the engine feature code. 6. Remove power from the track and place the switch back into the ‘RUN’ position.
|